mr
.
steam
®
Broadway Collection Towel Warmers Installation, Operation & Maintenance Instructions
_______________________________________________________________
5
Wiring
Box
Bracket
Screw
Mounting
Screw
Finished
surface
of wall
Extension
Bracket
Clamp Pieces
Clamp Screw
Cover
Wiring Box
Escutcheon
IMPORTANT:
LOOSENING END
CAPS WILL CAUSE INTERNAL LIQUID TO
ESCAPE AND CAUSE PRODUCT DAMAGE.
Level (not supplied)
Indicator
Light
Wiring Box
Allen
Wrench
Wiring Box
BOX CONTENTS:
• Towel Warmer • (4) Bracket Assemblies
• (4) Bracket Screws • Wiring Box Escutcheon
• (3) Wiring Box Screws • Allen Key
• (2) Set Screws • Instruction & Operation Manual
TO PREVENT SHOCK HAZARD, THE
ELECTRICITY MUST BE TURNED OFF AT THE MAIN
PANEL BEFORE ANY WIRING IS DONE.
1. Remove Towel Warmer and parts from the packing materials.
LOOSENING OR REMOVING END CAPS OR
HEATING ELEMENT ASSEMBLY WILL CAUSE INTERNAL
LIQUID TO ESCAPE AND CAUSE PRODUCT DAMAGE.
2. Using the allen key provided, loosen the wiring box set
screw. Set screw location varies by model as shown.
DO NOT remove the wiring box.
3. Gently rotate the wiring box as shown.
4. Locate the bracket on the wall by using the dimensions
given on page 3. The brackets are shown in the most
optimal location for mounting.
5. Using the screws provided secure the brackets to the wall.
6. Assemble the clamps and bracket extensions between the
top two and bottom two cross bars in each corner as shown
in the picture on the bottom of page 3 using the clamp
screw. Do not tighten the clamp screw, so the clamps are
free to slide for alignment purposes.
7. Align the bracket extensions with the wall mounted brack-
ets. Slide the towel warmer into place. Mark the location for
the wiring box escutcheon
8. Remove the towel warmer and secure the wiring box
escutcheon to the wall in the proper location.
9. Place the towel warmer on the brackets. Tighten the 4
bracket screws to secure the towel warmer in place. Tighten
the 4 clamp screws and place the 4 covers over the clamps.
Tighten the set screw on the bottom of the wiring box
escutcheon.
10. Tighten the wiring box set screw.
NOTE: The clamp pieces should be assembled so the grooves
fit the curve of the cross bars.
IMPORTANT NOTE:
See electrical rough-in
instructions on page 6.
Install Towel Warmers in upright
position only. Locate with indicator light on bottom as shown.
Failure to install properly may result in a hazardous
condition. See page 3.
!
WARNING
!
WARNING
!
CAUTION
INSTALLATION PLASTIC MOUNTING BRACKETS
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales