Mr. Steam 90C1ATSQPC Guía de instalación descargar pdf (Pagina 22)

CARE TIPS FOR ALL CONTROLS AND

STEAMHEADS

1. Use only mild soap and water on a soft cloth to clean

the control and steamhead.

2. DO NOT use abrasive cleansers.

3. If the decorative cover is damaged on the iTempo

r iTempo/Plus call Mr.Steam technical service for

replacement parts.

NOTE: Replacement of the decorative covers requires

removal and reinstallation of the control from the mounting

surfaces.

STEAM GENERATOR MAINTENANCE

Mr.Steam steambath generators require little maintenance.

Other than periodic draining, maintenance procedures are mini-

mal. Every 2 months, or more often in “hard” water areas, the

manual drain valve should be opened fully flushing out accumu-

lated materials, salts and other particles which are natural by-

products of boiling water.

Flush a minimum of two-three hours after the con-

trol has been turned off to insure that the water has cooled.

Draining immediately after a steam cycle may

expose PVC and other piping to high temperature water. Check

local codes. The unit will refill automatically when the control is

activated again. In areas of hard water, a Mr.Steam AutoFlush

system is recommended for generator longevity.

Failure to allow the water to cool will expose the

equipment and user to scalding water and cause property and

personal injury.

steam

Installation, Operation & Maintenance Manual

__________________________________________________________________________

H O M E O W N E R

0SETTING THE STEAM BATH

TEMPERATURE AND DURATION

Set the steam bathing temperature

according to personal preference, however it is highly rec-

ommended to begin steam bathing at a low temperature

etting to gauge comfort and safety levels. Set duration

to a maximum of 10 minutes to gauge comfort and safety

levels. This will allow the steam generator to heat up and

begin producing steam.

SAFETY AND OPERATING

INFORMATION

DO NOT install or use any iSteam

iTempo/Plus

™

, iTempo

™

, HomeWizard

™

or iGenie

controls

without reading and understanding the Mr.Steam steam

generator Installation and Operation Manual. Failure to

read and understand these instructions may result in an

inoperative or hazardous installation.

The peel and stick warning sticker located

in this manual must be read and permanently affixed in a

conspicuous location near the steam room. Failure to read

and affix this warning sticker in a conspicuous location

may result in serious injury or death.

If an iSteam, iTempo or iTempo/Plus control is installed

outside the steam room a Remote Temperature Probe

(PN MSTS or iMSTS) must be installed inside the steam

room per installation instructions supplied with the

Remote Temperature Probe. Failure to install according to

instructions will result in an inoperative control and

overheating of the steam room.

To prevent slip and fall hazards non-skip

strips must be installed on the steam room floor.

DO NOT alter or modify any Mr. Steam

product. Doing so may result in an inoperative or

hazardous installation and will void the UL listing and

warranty.

IMPORTANT NOTES:

Malfunction due to power spikes,

lightning, fire, freezing or flooding is not covered under

the warranty.

Discontinue use of the steam generator or control if the

steam generator is damaged or otherwise not functioning

properly. Doing so may result in an inoperative or

hazardous condition.

WARNING

CAUTION

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 45 46

Comentarios a estos manuales

Sin comentarios

Mr. Steam 90C1ATSQPC Guía de instalación Pagina 22

Comentarios a estos manuales